-
- Posts: 362
- Joined: Mon Jul 30, 2018 11:58 pm
I finally have my 3800-300TQ going more or less, but have run into a small issue with setting up the CP-8400.
Specifically, I can't figure out what's supposed to go in the I,II,III and waste positions.
I tried the Agilent ones I have, but they seem too tall and not large enough in diameter-I just did a run with them in place, and the needle didn't go anywhere near the solvent. The diameter, of course, is far too large for a standard 2mL AS vial to fit properly.
What vials should I be using in this?
Specifically, I can't figure out what's supposed to go in the I,II,III and waste positions.
I tried the Agilent ones I have, but they seem too tall and not large enough in diameter-I just did a run with them in place, and the needle didn't go anywhere near the solvent. The diameter, of course, is far too large for a standard 2mL AS vial to fit properly.
What vials should I be using in this?
