Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

Heater at fan assembly failed error message on Agilent DAD

http://www.chromforum.org/viewtopic.php?t=97664

Page 1 of 1

Heater at fan assembly failed error message on Agilent DAD

Posted: Fri Jul 19, 2019 7:47 pm
by Asha89
Good evening
I need your help or I'll spend my weekend over thinking.
My Agilent DAD shows the error message "error condition ERI 5 V overcurrent. Heater at fan assembly failed. Not ready conditions. Cell tag not ready". Does anybody know what does it mean? This DAD has been installed in March, so it's pretty new. This error message appeared at the end of an analysis, as my colleague said to me.

Thank you

Re: Heater at fan assembly failed error message on Agilent DAD

Posted: Sat Jul 20, 2019 10:20 pm
by ATAlR
Do you have a 15pin cable connected to ERI port? Remove it, does the system recovers after reboot or is it failing back to error state?
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/