Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

Valve temperature adjustment for Buck Scientific Model910 GC

http://www.chromforum.org/viewtopic.php?t=8629

Page 1 of 1

Valve temperature adjustment for Buck Scientific Model910 GC

Posted: Sat Jun 14, 2008 10:13 am
by qazaqaz
I try to adjust temperature of GC valve but I can't set (skrew spint adjust) more than 188C (both local setpoint and total setpoint) . This temp is its limit or not? I don't have manual because it is very old. I want to set to 220C. if someone can adjust, plaese tell me how or tell me how to get manual. I send require manual and problem to Buck Scientific but don't have any response.
-Thank you for all answer and discuss-
^___^

Posted: Mon Jun 16, 2008 5:10 pm
by AICMM
Contact SRI, they probably built the GC, and ask them for advice.

Best regards.
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/