Chromatography Forum

Which type of interface are you using in Empower? Any special reason why the particular kind?

I use the PRO Interface. I am user since Millenium32, so for a very long time. I just cannot get used to use the Quickstart interface. In the Pro, you have complete control over all the projects etc..

Hope this answers your question

I use the PRO Interface. I am user since Millenium32, so for a very long time. I just cannot get used to use the Quickstart interface. In the Pro, you have complete control over all the projects etc..
Hope this answers your question

could have been my feedback.
Exactly the same for me.

Agree with gstaepels: We're not using Empower at all at the moment, for various reasons, but when we were, we were very definitely Pro interface users. Most of the lab had Millenium experience and found Quickstart confusing. Even the new users got stuck more often with Quickstart because the older users couldn't help them.

As an admin, I always favored the pro, but gave other users a choice of either because quick start can be quicker for a few operations.

Hi,

I am a Pro interface user on EMPOWER for the last 5 years however, my colleagues who are quite new to EMPOWER are all using Quickstart interface and I am not used to the quick start interface at all so I have a few questions I would like to ask:
1. On quick start interface, can you create a sample set from an existing sample set? I try open up an existing sample set from Browse Project however the injections were all in red since its a sample set that has been ran before. Is this normal?
2. My colleague always create the sample set manually from quickstart interface and then run the sample set. However, some of these sample sets cannot be access from the Browse project in the Professional Interface. Is this normal?

Hope any of you would be able to help with my questions!
would appreciate the help! thank you so much!