Page 1 of 1
Setting up an ELSD detector
Posted: Tue Jun 13, 2017 8:41 am
by Sam Adamson
I am trying to set up an Agilent 1100 series to a PL 2100 ELSD for surfactant analysis.
I have the detector and HPLC but i am unsure of what other components will be needed to get the system up and running.
Any help would be greatly appreciated.
Re: Setting up an ELSD detector
Posted: Tue Jun 13, 2017 9:27 am
by tkubowicz
Hello
If you're going to use Chemstation/OpenLab as software you will need Agilent 35900E Dual Channel Interface to have signal from ELSD in Chemstation.
Regards
Tomasz Kubowicz
Re: Setting up an ELSD detector
Posted: Tue Jun 13, 2017 3:44 pm
by Consumer Products Guy
Hello
If you're going to use Chemstation/OpenLab as software you will need Agilent 35900E Dual Channel Interface to have signal from ELSD in Chemstation.
Regards
Tomasz Kubowicz
That's what we did with our ELSD and other external detectors.
Re: Setting up an ELSD detector
Posted: Tue Jun 13, 2017 3:57 pm
by Andy F
This may be stating the obvious, but you need a gas (nitrogen) supply for the nebuliser.