-
- admin
- Site Admin
-
- Posts: 647
- Joined: Wed Aug 11, 2004 12:19 am
By Joe Baird on Friday, August 6, 2004 - 07:18 am:
Does anyone know the relationship between angstroms to mesh in regards to media? In the past I actually had a conversion chart but have since lost it.
-------------------------------------------------------------------------------------------------------
By Ron on Friday, August 6, 2004 - 07:34 am:
There used to be a table in the CRC Handbook of Chemistry and Physics related mesh size to other units of measurement. My copy is very old, and I don't know if the chart is in newer editions.
-------------------------------------------------------------------------------------------------------
By Fabiano on Friday, August 6, 2004 - 07:51 am:
There´s such charts in Cole-Parmer catalog, but they go only to 400 mesh that correspond to 37um.
-------------------------------------------------------------------------------------------------------
By bill tindall on Saturday, August 7, 2004 - 06:01 pm:
Keep in mind that mesh will be equivalent to a micron range that will pass the screen. I have data on diamond powder to 50000 mesh which is about 1 micron. When I have seen comparisons it seems to be different for different abrasive products, that is to say 1000 mesh for this abrasive is not the same micron size as 1000 mesh for that.
Does anyone know the relationship between angstroms to mesh in regards to media? In the past I actually had a conversion chart but have since lost it.
-------------------------------------------------------------------------------------------------------
By Ron on Friday, August 6, 2004 - 07:34 am:
There used to be a table in the CRC Handbook of Chemistry and Physics related mesh size to other units of measurement. My copy is very old, and I don't know if the chart is in newer editions.
-------------------------------------------------------------------------------------------------------
By Fabiano on Friday, August 6, 2004 - 07:51 am:
There´s such charts in Cole-Parmer catalog, but they go only to 400 mesh that correspond to 37um.
-------------------------------------------------------------------------------------------------------
By bill tindall on Saturday, August 7, 2004 - 06:01 pm:
Keep in mind that mesh will be equivalent to a micron range that will pass the screen. I have data on diamond powder to 50000 mesh which is about 1 micron. When I have seen comparisons it seems to be different for different abrasive products, that is to say 1000 mesh for this abrasive is not the same micron size as 1000 mesh for that.
