Software Totalchrom and a signal from ECD , GC PE Clarus 680
Posted: Thu May 21, 2015 11:35 pm
1. I see on GC Perkin Elmer Clarus 680 LCD display the ECD signal on the level ca 20mV - I mean baseline not raw data, but when I make an analysys, the baseline starts always on the level 150mV in TotalChrom software. Why?
2. Can I ask for a sequence of commands to get "Start Monitor", now this command is still "gray" despite loading method
Greg
2. Can I ask for a sequence of commands to get "Start Monitor", now this command is still "gray" despite loading method
Greg