Varian 3800 remain at "equlibrating"
Posted: Sun Sep 01, 2013 4:57 am
I have a Varian GC 3800 that worked 2 year ago but has not been turned on since.
When I load a method and after all variables set at desired values (flow, temperature and .... ), GC is stuck on "equilibrating" and dose not go to "ready" situation . I also select a name for my injection and press the "injection" in software, but GC is not ready for injection.
Another problem is FID is shut-down after several second. Each time I turn it on manually, It turns off again. All gases (H2, Air and make-up gas flows are correct). FID temperature is 200 0C and electronic is on.
Any help would be appreciated.
When I load a method and after all variables set at desired values (flow, temperature and .... ), GC is stuck on "equilibrating" and dose not go to "ready" situation . I also select a name for my injection and press the "injection" in software, but GC is not ready for injection.
Another problem is FID is shut-down after several second. Each time I turn it on manually, It turns off again. All gases (H2, Air and make-up gas flows are correct). FID temperature is 200 0C and electronic is on.
Any help would be appreciated.