Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

Unwanted Peaks in Baseline for GC-FID Agilent 7890

http://www.chromforum.org/viewtopic.php?t=23215

Page 1 of 1

Unwanted Peaks in Baseline for GC-FID Agilent 7890

Posted: Fri Aug 16, 2013 6:43 pm
by anajafi
We are dealing with some difficulties regarding the FID for 7890 Agilent model. Basically, when FID signal drops to 10 pA, some spiked peaks come out in the irregular time intervals. We have already change the FID jet and cleaned the collector electrode, but the problem still persists. I observed the problem without injecting solvents or analytes.

I would appreciate it if someone could give some troubleshooting advice to solve the issue.

Re: Unwanted Peaks in Baseline for GC-FID Agilent 7890

Posted: Mon Aug 19, 2013 7:02 am
by Peter Apps
It sounds like electrical or electronics problems. Please post an example of the chromatogram. Instructions on pasting chromatograms are in a sticky at the top of the GC page.

Peter
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/