Start Run on Agilent G1376A CapPump using Finnigan Micro AS
Posted: Thu May 16, 2013 9:47 pm
Does anyone know how to send a start run signal from a Finnigan Micro AS autosampler to an Agilent G1376A CapPump?
Connectivity for the Micro AS autosampler seems well-documented (http://sjsupport.thermofinnigan.com/tec ... rdware.pdf), but the Agilent side is confusing.
Thanks,
David Simpson
Virginia Commonwealth University
Connectivity for the Micro AS autosampler seems well-documented (http://sjsupport.thermofinnigan.com/tec ... rdware.pdf), but the Agilent side is confusing.
Thanks,
David Simpson
Virginia Commonwealth University