Hi all,

As you can see, I'm new to this forum, and this is my first post.

We've recently invested in a new Hitachi gpc with ezchrom elite software.
We're just starting to get familiar with it, and everything is ok as far as basic results is concerned (overlay, Mw value, etc)

Running ahead of our software training next week, I'm wondering, does anyone of you know of a report template that will show:

sample information
chromatogram
(integration start and end displayed)
flow rate marker (toluene) peak flagged so you can check the correct one was picked
Mw
Mn
Mw/Mn

Apart from that, I'd like to have some integration values, but only for the region where the Mw calculation is done: total area for the region, and area (percentage) values for the individual peaks. furthermore, I'd like those peaks labeled with Mp instead of elution time.

Is all of that possible with ezchrom?

Best regards

Tom