-
- Posts: 55
- Joined: Wed Jan 19, 2005 7:22 pm
I was attempting earlier to reset the transport alignment for a G1313 autosampler within ChemStation. I entered the following command into the command line:
Print sendmodule$(lals, "tray:alig 0.00,0.00")
Nothing seems to overtly happen, but I also don't get an error message. The command line just goes blank again. Does this mean I was successful, or should I see the G1313 try to reinitialize after this command? Thanks for any feedback!
Print sendmodule$(lals, "tray:alig 0.00,0.00")
Nothing seems to overtly happen, but I also don't get an error message. The command line just goes blank again. Does this mean I was successful, or should I see the G1313 try to reinitialize after this command? Thanks for any feedback!
