Using Waters2695 with Agilent 82350B GPIB for Masslynx
Posted: Fri Aug 31, 2012 3:02 pm
I need your help to figure out the possibility of this setup for my LC-PDA/Flu detectors.
My Empower and original GPIB crushed, so that I am trying to use MassLynx through Agilent 82350B GPIB to operate Waters2695 system, but with PDA/Flu detectors.
However, MassLynx fails to recognize 2695 (i.e., communication error) due to an incorrect GPIB and pump IDs.
As I am not so familiar with the hardware parts of LC, please help me how I could set this up, if it is possible.
At least, I know GPIB is properly working on my computer, based on device manager information.
On MassLynx, under configuration setup, I suspect that 2695 pump ID and/or GPIB board ID (to be chosen from 0 through 30) are incorrect.
I have tried all 31 GPIB board IDs, but that still did not work.
Thanks for any information that you can have for me.
My Empower and original GPIB crushed, so that I am trying to use MassLynx through Agilent 82350B GPIB to operate Waters2695 system, but with PDA/Flu detectors.
However, MassLynx fails to recognize 2695 (i.e., communication error) due to an incorrect GPIB and pump IDs.
As I am not so familiar with the hardware parts of LC, please help me how I could set this up, if it is possible.
At least, I know GPIB is properly working on my computer, based on device manager information.
On MassLynx, under configuration setup, I suspect that 2695 pump ID and/or GPIB board ID (to be chosen from 0 through 30) are incorrect.
I have tried all 31 GPIB board IDs, but that still did not work.
Thanks for any information that you can have for me.