Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

Injection Tower Error

http://www.chromforum.org/viewtopic.php?t=19994

Page 1 of 1

Injection Tower Error

Posted: Wed May 30, 2012 10:54 pm
by m.finnBMBM
6890/5973 w/7683. When I remove the injection tower to do a manual injection and put the 7683 back after the run is complete to do an automated injection I get an error message. What is the proper protocol for removing the injection tower to do a manual injection and then putting it back?

Re: Injection Tower Error

Posted: Thu May 31, 2012 11:01 am
by Bigbear
Make sure there is nothing interfering with the tower preventing it from making contact with the GC. It has to sit level and flat againgt the mount.
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/