Using the 7693 autosampler to prepare standards
Posted: Fri May 18, 2012 3:33 am
Hi all,
Is there anyone out there using the sample and standard preparation capabilities of the Agilent 7693 autosampler.
In particular I was going to set it up to prepare a series of standards from a stock, and eventually migrate this to an internal standard addition as well.
I haven't found too many articles on how to do this. I did find an example procedure in the Agilent help section for the MSD chemstation but the steps aren't described too well & I am not convinced that the full information is provided.
I am curious to see if people using this autosampler see the sample/standard preparation capabilities as usable/valued features of the autosampler or just a gimmick that isn't worth the time to use..
Any comments
Thanks
Kevin
Is there anyone out there using the sample and standard preparation capabilities of the Agilent 7693 autosampler.
In particular I was going to set it up to prepare a series of standards from a stock, and eventually migrate this to an internal standard addition as well.
I haven't found too many articles on how to do this. I did find an example procedure in the Agilent help section for the MSD chemstation but the steps aren't described too well & I am not convinced that the full information is provided.
I am curious to see if people using this autosampler see the sample/standard preparation capabilities as usable/valued features of the autosampler or just a gimmick that isn't worth the time to use..
Any comments
Thanks
Kevin