I need your help to figure out the possibility of this setup for my LC-PDA/Flu detectors.
My Empower and original GPIB crushed, so that I am trying to use MassLynx through Agilent 82350B GPIB to operate Waters2695 system, but with PDA/Flu detectors.
However, MassLynx fails to recognize 2695 (i.e., communication error) due to an incorrect GPIB and pump IDs.
As I am not so familiar with the hardware parts of LC, please help me how I could set this up, if it is possible.
At least, I know GPIB is properly working on my computer, based on device manager information.
On MassLynx, under configuration setup, I suspect that 2695 pump ID and/or GPIB board ID (to be chosen from 0 through 30) are incorrect.
I have tried all 31 GPIB board IDs, but that still did not work.

Thanks for any information that you can have for me.