Page 1 of 1
swap the filament on Agilent GCMS
Posted: Wed Dec 28, 2011 7:42 pm
by sepscientologist
I remember that there are two filaments installed. How do I switch them?
Re: swap the filament on Agilent GCMS
Posted: Wed Dec 28, 2011 9:10 pm
by mty
On the tune page, one of the parameters in the upper left part of the parameters box, you can change the filament.
Sorry--a bit incoherent, since I'm in my office and not at my instrument.
M
Re: swap the filament on Agilent GCMS
Posted: Tue Jan 03, 2012 3:22 pm
by Bigbear
If it's a 5970 there is a toggle switch at the rear of the analyzer assembly.
Re: swap the filament on Agilent GCMS
Posted: Mon Jan 09, 2012 4:42 pm
by sepscientologist
Got it. Switch to 'tune' view. Choose 'manual tune'. There you can see which filament is active and switch.