method files with chemstation
Posted: Fri Dec 23, 2011 8:16 pm
Hi all,
I'm preparing a method file in Chemstation based on one that other people are using. They send us the method file but unfortunately we cannot open it in our Chemstation (probably because our version is older) so I have been reviewing the file named IQ1.MTH to interpret how the method is in fact.
I could understand almost all the parameters but mainly I cannot figure out those related to the Front Inlet.
Does anyone know where I could find the meaning of these parameters?
IFCW
IFZW
IFCR
IFDP
Other unknown parameters are:
GCPO
GCPU
For the Front Inlet (EPC Purged Packed Inlet), in the Chemstation I can only set:
- Total flow
- Heater setpoint temperature
but I cannot do any ramp and I have the impression that the parameters that I cannot understand have something to do with this.
Can anyone help me with this problem?
(in the Agilent webpage I could not find anything about this IQ1.MTH file)
Thank you in advance for your help!
I'm preparing a method file in Chemstation based on one that other people are using. They send us the method file but unfortunately we cannot open it in our Chemstation (probably because our version is older) so I have been reviewing the file named IQ1.MTH to interpret how the method is in fact.
I could understand almost all the parameters but mainly I cannot figure out those related to the Front Inlet.
Does anyone know where I could find the meaning of these parameters?
IFCW
IFZW
IFCR
IFDP
Other unknown parameters are:
GCPO
GCPU
For the Front Inlet (EPC Purged Packed Inlet), in the Chemstation I can only set:
- Total flow
- Heater setpoint temperature
but I cannot do any ramp and I have the impression that the parameters that I cannot understand have something to do with this.
Can anyone help me with this problem?
(in the Agilent webpage I could not find anything about this IQ1.MTH file)
Thank you in advance for your help!