GC Chemstation Instrument Fault Detection

[brummie99]

Anybody know of a hook or macro code that could get triggered whenever an instrument fault is detected e.g. autosampler fault or communications fault causing the sequence to stop?

I want to insert some code that triggers an email to be sent whenever an instrument fault occurs.

I'm using version B.01.03

[LabProARW]

I would love to be able to do this too! In my playing around with the macros I had difficulty finding where to 'insert' them or 'load' them from inside of Chemstation. When I found one place in the pre and post sequence run page I learned that if someone aborts the run then the macro did not launch. My macro found the data file - renamed it - moved it to a 'hot folder'. Again when a user decided that the run had gone long enough and told it to stop, my post run macro did not run.

[MX304]

From what Agilent has told me, no, it isn't possible to set up alerts like that.

[george_jibuti]

From chemstation it is not possible, but I thin Agilent Lab Monitoring And Diagnostic Software has such function
(Basic edition of this software is free and comes with instrument)