Agilent 1100 labview error
Posted: Mon Oct 03, 2011 10:05 am
Hello.
I'm trying to hook up a Agilent 1100 system to a computer via ethernet and control it through labview with the ag1100 drivers.
I've managed to get the computer to talk to the system and assign it an IP-address but when I run the pump example it returns "Error 10000501 syntax error".
I haven't been able to find and documentation about this error code and since it's a proprietary driver I cannot open up the VI that's causing the trouble (the configure pump one). The pump in the system is a G1311A that should be supported by the drivers.
Very thankful for any kind of help, I'm totally stuck here...
I'm trying to hook up a Agilent 1100 system to a computer via ethernet and control it through labview with the ag1100 drivers.
I've managed to get the computer to talk to the system and assign it an IP-address but when I run the pump example it returns "Error 10000501 syntax error".
I haven't been able to find and documentation about this error code and since it's a proprietary driver I cannot open up the VI that's causing the trouble (the configure pump one). The pump in the system is a G1311A that should be supported by the drivers.
Very thankful for any kind of help, I'm totally stuck here...