Page 1 of 1
EPC calibration GC6890
Posted: Tue Apr 20, 2010 6:17 pm
by astroguille
Hi people!
I work at GC6890.
Did anybody calibrate the EPC pressure sensors? When & How is that necessary?
Best regards
Posted: Tue Apr 20, 2010 6:24 pm
by Jumpshooter
Agilent calibrates them at the factory prior to delivery.
Posted: Tue Apr 20, 2010 6:43 pm
by astroguille
Yes, but I refer to The Zero pressure sensors.
Posted: Tue Apr 20, 2010 6:44 pm
by astroguille
Yes, but I refer to pressure sensors zero.
Posted: Wed Apr 21, 2010 6:16 pm
by Ron
There should be a produre that can be used to calibrate the zero point and offset, these are the settings that most often need adjustment. Check the Agilent web site to see if the procedure is posted.