Chromatography Forum

I have been tasked with re-animating two zombie 6890N GCs. There are no computers. There is no software. Just two left for dead units sitting on a bench.

To start, just two simple (I hope) questions if anyone knows:

What is the most modern Agilent software version I can use with these instruments?

What is the most modern OS I can use with that software?

If I can get answers to those there is a good bet I will have more questions.

Thanks in advance to anyone who can get me started on this.

at a minimum, OpenLab CDS 2.8 should work with your GC per
https://www.agilent.com/en/support/soft ... penlab-cds

Try our UniChrom.
https://www.unichrom.com/chrom/ucdle.php

Should work under Winows/Linux/Mac

User Guide: https://www.unichrom.com/chrom/ug5eng.pdf

Installation manual for 6890: https://www.unichrom.com/hp6890/Agilent ... %20eng.pdf

Gizmo,

As noted, Chemstation. $$$$$

Also, Chromeleon, $$$$ (estimated.)

Also, as noted, Unichrom, personally no experience with.

Also, Clarity, limited experience but very workable and a lot less expensive. $$

Best regards,

Aicmm