Page 1 of 1
computerisation of shimazdu 14B
Posted: Tue Oct 27, 2009 2:25 pm
by jlkishore
Hi all,
I have a shimazdu 14B GC and have a CR8A chromatopac data station which just prints the chromatogram. I want to connect this GC to a PC so that I can save all my chromatograms on computer. Can anyone suggest suitable software for this. How can I linkup the GC and PC.
Thanks
Posted: Tue Oct 27, 2009 5:21 pm
by AICMM
jlkishore,
How much do you want to spend and do you want to just collect the data or do you need to control things on the GC like valves and heated zones. Those two questions will start to drive your answer. I am doing the same thing for a customer now who only needs a few contact closures and data collection, which is much easier than controlling heated zones, splitter valves, etc....
Best regards.
Posted: Wed Oct 28, 2009 9:21 am
by varossf
Hi, the Shimadzu GC14B is supported by the EZChrom Elite Workstation software available at Agilent. It does full control. Contact your local representative @ Agilent
.
Posted: Thu Oct 29, 2009 10:40 am
by jlkishore
jlkishore,
How much do you want to spend and do you want to just collect the data or do you need to control things on the GC like valves and heated zones. Those two questions will start to drive your answer. I am doing the same thing for a customer now who only needs a few contact closures and data collection, which is much easier than controlling heated zones, splitter valves, etc....
Best regards.
Hi,
I am just looking for data collection. what would be the cost for this..
Thanks