Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

Perkin Elmer Clarus 500 from USA to Europe

http://www.chromforum.org/viewtopic.php?t=115434

Page 1 of 1

Perkin Elmer Clarus 500 from USA to Europe

Posted: Tue Jan 25, 2022 12:39 pm
by greg07
Hello,

I am writing from Europe. I am using a Clarus 500 split / splitless / FID chromatograph. I want to extend this chromatograph with a second channel, also Split / slpitless / FID. It is not profitable to buy parts separately. I would like to buy a used chromatograph in the USA and rearrange the parts. I have a question, will all internal modules work properly with 230V?

Regards

Re: Perkin Elmer Clarus 500 from USA to Europe

Posted: Thu Jan 27, 2022 5:45 pm
by DR
If the unit you have requires throwing a switch, changing cords and (maybe) changing the fuse on the back panel, then it should be Yes, the internals are the same.

Re: Perkin Elmer Clarus 500 from USA to Europe

Posted: Fri Jan 28, 2022 12:43 pm
by dblux_
According to "Clarus 500 GC Installation Guide" you only need to "change the wiring on the AC Distribution P.C. board as described in the following procedures".
Procedure is printed on page 85 of above mentioned guide.
https://www.perkinelmer.com/CMSResource ... lation.pdf
So every Clarus 500 GC is suitable for different power supplies around the world. Very convenient, especially for manufacturer.
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/