Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

Furnace Injector Module for Agilent 6890/7890

http://www.chromforum.org/viewtopic.php?t=102314

Page 1 of 1

Furnace Injector Module for Agilent 6890/7890

Posted: Thu Feb 13, 2020 4:08 pm
by bry_fieri
Does anyone have any experience with pyr-gc furnaces for polymer analysis? Where to buy one and if they can be used with FID instead of MS?

Re: Furnace Injector Module for Agilent 6890/7890

Posted: Sat Feb 15, 2020 11:20 pm
by James_Ball
Not sure if it is the same thing, but 30 years ago in college I used a Pyroprobe on an old Varian GC with FID to do pyrolysis studies on coal. You should be able to use it with any detector if you have one to fit the GC inlet. It is just a different sample introduction method and should be independent of the detector that is being used.
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/