Advertisement

NO peaks in TCD detector PerkinElemer clarus 580

Discussions about GC and other "gas phase" separation techniques.

4 posts Page 1 of 1
Good day!!
I am using Perkin elmer clarus 580 model equiped with FID and TCD detector.No peaks are seen while eluting permanent gases through Shincarbon ST column connected to TCD. However previously all peaks were eluted without any problem the GC system was offline for a while(1.5 months) and after that no peaks were seen eluting from TCD.
Condition of column at high temperature and oxygen-free carrier gas
Column is already conditioned for12 hours in constant carrier gas flow
TCD is working? Input air - what TCD reaction? What working condition -temp., flow?
4 posts Page 1 of 1

Who is online

In total there are 10 users online :: 0 registered, 0 hidden and 10 guests (based on users active over the past 5 minutes)
Most users ever online was 4374 on Fri Oct 03, 2025 12:41 am

Users browsing this forum: No registered users and 10 guests

Latest Blog Posts from Separation Science

Separation Science offers free learning from the experts covering methods, applications, webinars, eSeminars, videos, tutorials for users of liquid chromatography, gas chromatography, mass spectrometry, sample preparation and related analytical techniques.

Subscribe to our eNewsletter with daily, weekly or monthly updates: Food & Beverage, Environmental, (Bio)Pharmaceutical, Bioclinical, Liquid Chromatography, Gas Chromatography and Mass Spectrometry.

Liquid Chromatography

Gas Chromatography

Mass Spectrometry