My lab has a 1200 series Aglient HPLC with a HiP-ALS SL auto sampler. The auto sampler has room for two plates of vials or a 96 well, but it also has 10 vials to the right of the plate positions. I don't know how these are referred to.

The manual for the auto sampler refers to them as "Vial 1-10", and when we configure the module in Xcalibur the selection is "2 deep well plates + 10x2 mL vials". I'm assuming they should be accessible.

I tried to refer to it as "3:XY" but only 3:A1 was recognized by the xcalibur sequence manager. 3:A2+ were not.

Does anyone know how I access these vial positions from Xcalibur?