by
Hollow » Mon Sep 17, 2018 7:33 pm
I guess you should be able to remove the LAN interface module from the Agilent module.
Then there are some dip switches which configures how the IP adress is set.
One setting assigns the default values, from there you can set a new IP adress by Telnet session.
Search for the manual of your type of interface card at Agilent
https://www.agilent.com/search/en/suppo ... +900007550eg: G1369A or G1369B
Remember, if you want to connect the PC directly to the LAN module, make sure to use a cross-over Ethernet cable. Or use a network switch and two 'normal' cables
And of course set the IP adress of the PC temporarly to the same network to get a connection.