-
- Posts: 9
- Joined: Tue Jun 05, 2012 2:21 pm
I am trying to connect a PL-ELS 2100 ELSD detector to an Agilent 1100 system, with DAD.
So far, I got a 35900E, which had a GPIB-card in it, but I replaced that with a G1369A LAN card.
As telnet didn't work, and I don't have any bootp to use I just set the IP to default (192.168.254.11).
I then changed the IP of the 1100 system to 192.168.1.102, and after doing this I can ping both systems and get response.
So far all is good, I go into system setup and add the 35900E along the already configured 1100 DAD-system, and then start the Chemstation software.
Now I get an error something like: Can't talk to 35900, select code or check power and I can't get past this error.
The 35900 leds that are on are: Power and Not ready.
Any suggestions on how I should proceed?
I am a bit worried the 35900E/G1369A isn't working properly communication-wise, since this but also the fact that I couldn't connect to it through telnet either.