-
- Posts: 34
- Joined: Tue May 24, 2011 10:21 am
having a few issues with Empower3, i would normally go to Waters with this, but the latest ticket I have raised has illicited lengthy waits and then irrelevant replies, which look suspiciously like someone just replying for the sake of ticking a box, but with no knowledge at all.
ok moan over.
the main issue is as follows.
when processing a sample set, I always end up with three curves, corresponding to the three listed components. one is the active, one is the internal standard and one is another named peak.
the Cal curve required is for the ratio of Active:ISTD
the curve for the ISTD alone is 5 points all roughly overlaid, so essentially a single point cal. the one for the other named component appears to be the ratio of the component to ISTD and is fairly random.
my question. is there a way to restrict the curves generated to only the Active:Istd. and omit the others
thanks