-
- Posts: 32
- Joined: Mon Jul 03, 2017 6:25 pm
I use front injector
I have a Y at the inlet and have two columns, one going to FID A and the other to FID B
On the method I select SIG A and SIG B, front injector
In pre run, I can monitor both Detector signals, but once the run starts, for some reason, the computer output is the same (Det A) for both Sig A and Sig B. I can not see the other signal.
I am wondering if I am missing something. If any of you have the same system please advise.
Thanks in advance for any help.