-
- Posts: 3
- Joined: Fri Jul 21, 2017 1:28 pm
from one day to onother, my Agilent MSD 5973 (coupled to a GC 6890) started to stop runs during the sequence. When opening the logbook, the error is staed as follows:
1101, ''({MON}): Unrecoverable mass spec fault:2''. (snaphost: https://ibb.co/N7JFF61)
Sometimes the sequnece is halted after only one run, other times, after about 8 hours. I did not found any help either on the Net or on the manuals (I can not find any error list). I have also tried to change the filament but nothing changed.
Can anyone help me?
Thanks in advance for all your suggestions
Luca