Chromatography Forum

Chromatography Forum is a public discussion group where you can post questions, news, or messages of interest to chromatographers everywhere, but you must be registered to participate (registration is FREE). If you are a registered user, please log in.
http://www.chromforum.org/

The problem with the solenoid valve

http://www.chromforum.org/viewtopic.php?f=2&t=90544

Page 1 of 1

The problem with the solenoid valve

Posted: Mon Nov 05, 2018 6:04 am
by sana70
Hi
I use DANi master GC-FID.
I have problem with solenoid valve (brand: SIRAI V366B01BL). I hear leaking at the solenoid valve, when i inject sample to the GC after a few minute air leak will stop and we hear no sounds but after finish the run time leak start again. now i dont know how to fix it?

Re: The problem with the solenoid valve

Posted: Mon Nov 05, 2018 1:39 pm
by rb6banjo
I assume that you tried tightening the fittings for the tubing that goes into the valve. If not, do that first. If that doesn't fix the problem, you can always buy a new valve.

Re: The problem with the solenoid valve

Posted: Mon Nov 26, 2018 6:59 pm
by AICMM
Are you injecting splittless and going to split at some time? Or is this a valve injection?

Best regards,

AICMM
All times are UTC
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/