Headspace Needle broke 7697A

Discussions about GC and other "gas phase" separation techniques.

4 posts Page 1 of 1

Any body know replacement part for broken needle on 7697A Headspace transfer line or how to fit a new one ?

one bent to breaking point some how !

As far as I know needle for transfer lines can be from 7694 HS:

-Needle, headspace transfer line, deactivated 0.5 mm OD 2322590004

-Needle for transfer line, 0.25 mm ID, 0.5 mm OD, nickel 301-016-HSP

-Needle, headspace transfer line, deactivated 0.7 mm OD 2322590005

-Needle for transfer line, 0.4 mm ID, 0.8 mm OD, nickel 301-015-HSP

You can attach transfer line from HS to GC inlet lines and you don't have to use this needles anymore.


Tomasz Kubowicz
Hi ,

Thanks for the info , though arnt these needles for the 7694 transfer line setup ?

the 7697 is slightly different and has a supporting bracket and fitting round the needle and I cant see how the broken needle can be replaced with a new one
The needle then goes into the inlet
Hi ,

Still no takers on this

HP7697 with transfer line and support bracket .. needle broke off

How do I replace this ?

4 posts Page 1 of 1

Who is online

In total there are 6 users online :: 0 registered, 0 hidden and 6 guests (based on users active over the past 5 minutes)
Most users ever online was 234 on Tue Feb 06, 2018 7:33 am

Users browsing this forum: No registered users and 6 guests