Oxygen Combustion Flask

Discussions about sample preparation: extraction, cleanup, derivatization, etc.

3 posts Page 1 of 1
Hello all,
I was burning sulphur in an oxygen combustion flask and the stopper was stuck in the neck of it. How can I remove it without breaking it? Thanks in advance.
Hello. Try to knock a bit.
Best regards,
Dmitriy A. Perlow
Another possibility is to use a heat gun on "low" (or, even better, a hair dryer) to *gently* warm the neck of the flask. That may expand it enough to let you pull the stopper.
-- Tom Jupille
LC Resources / Separation Science Associates
tjupille@lcresources.com
+ 1 (925) 297-5374
3 posts Page 1 of 1

Who is online

In total there are 7 users online :: 0 registered, 0 hidden and 7 guests (based on users active over the past 5 minutes)
Most users ever online was 234 on Tue Feb 06, 2018 7:33 am

Users browsing this forum: No registered users and 7 guests